The Vinyl Cutting Hack You Need When Renovating The Floor
One of the most significant renovations you can do to your home is to replace the flooring. The style of the floor sets the tone for a room, and it becomes the backdrop against which you create your interior design. Choosing vinyl flooring for this renovation carries a lot of benefits. Not only is it more affordable than other materials, but it's available in a wide range of styles, even ones that mimic the look of wood or stone. Another advantage is that it's easier to install than other materials. However, it's helpful to have a strategy in mind before starting this project, especially when it comes to the tricky process of laying the vinyl in a corner of the room. The best way to tackle this challenge is to use a simple hack that involves securing a flat block beneath the vinyl to help you measure the edges.
By the time you reach the corner, it's necessary to be exact because you've already laid a large portion of the flooring. It's recommended to begin laying the flooring in the middle of the room so that the design is centered. However, this also means that there isn't much room for error in your measurements. The nice thing about this hack is that it can be done precisely, even without removing the baseboards. The tools you'll need are a small, flat block, some double-sided tape, a piece of cardboard, and your flooring knife.
The best way to cut vinyl in a corner
Take the block and wedge it firmly in the corner, then cut off a piece of the double-sided tape and apply it to the block. Next, fold the flooring so that it fits tightly in the corner and adheres to the block, tucking the edges in securely. Now fold the flooring back to reveal where the block is attached. The outer corner of the block represents the corner that you're trying to match. Place a piece of cardboard under the vinyl where the block is attached. Then trace your knife around the two outside edges of the block. You should have just replicated the shape of the corner of the floor. Remove the block and press the vinyl into place in the corner.
At this point, you can continue to trim the excess flooring material along the side of the room. By using the block as the initial guide, you've made a perfect match with the corner and aligned your materials with the wall. By simplifying this one step, your new floor renovation is much more manageable. Moreover, it's a wonderful way to give your home an updated look without going over budget. This hack will simplify this process and provide beautiful results.