How To Properly Attach The Weed Whacker Line To Your Ryobi's String Trimmer

Replacing the line on a weed whacker is one of those tasks that feels more complicated than it should be. Many traditional string trimmer heads require full disassembly, winding the line manually, and carefully threading through small openings. This can quickly test your patience when the line gets tangled or slips during the process. Some of the best Ryobi weed whackers try to address these pains with the Reel Easy+ string head which features a simpler reloading mechanism designed for efficiency. The speed winder head allows line replacement without having to disassemble the entire thing.

The system works with pre-cut line segments, but they also offer bulk line that you can measure and cut yourself. The design includes clear arrows and pre-marked eyelets to eliminate the guesswork when feeding the line through. It is also good to know exactly how often you should be changing the string on your weed whacker so as not to lose money on wasted string. Even with this simplified system, incorrect loading can lead to uneven line distribution, so it is important to follow the correct steps to get a proper replacement. When done correctly, however, the process takes just a couple of minutes which is an improvement over traditional trimmer heads that can often require pliers, screwdrivers, and considerable patience.

To load the line in Ryobi's string trimmer, start by removing the battery so there is no power going to it. Then, cut about 16 feet of trimmer line from a bulk spool, or just have a pre-cut segment ready. Align the arrow on the trimmer head with the openings so you can see straight through the head. This makes sure that the internal parts are in proper position for line-feeding. Insert one end of the string through the hole until it pops out the other side and pull so there are equal lengths sticking out of both sides. With the line threaded, grab the small crank tool that comes with your trimmer and attach it to the center of the spool. Rotate clockwise, following the arrows, and you will see the string begin to feed into the head. Once you've got about 6 to 8 inches of line hanging out on either side you can stop.

If the string does get jammed or you encounter too much resistance, detach the entire head by pressing down on it while turning it counterclockwise. Clean away debris inside, untangle the line, and reassemble by aligning the arrows again and twisting until it locks. You can also try soaking your weed eater string if it's been sitting in your garage for too long to help it become more pliable. While no system is completely foolproof, Ryobi's design certainly minimizes common frustrations when it comes to replacing the string in your weed whacker and helps you get back to lawn work much faster.