Turn PVC Pipes Into A Creative Way To Light Up The Outside Of Your Home
We may receive a commission on purchases made from links.
Making your outdoor space visually pop at night shouldn't always oblige you to rethink your hardwiring or be stressed at the thought of a pricier power bill. If you need additional light on your front patio, your backyard, or on the front of your garage, making a few solar-powered fixtures could be a more affordable and sustainable option to consider. So say goodbye to pricey outdoor lights and build a wall-mounted sconce out of a PVC pipe, some plywood, and a solar-powered puck light.
Getting materials for this DIY can be accomplished within a single trip to your local hardware store, or a couple tabs open on your browser. Look for a 2-foot long PVC pipe that's 3 inches wide, which will be enough to make two of these lamps. You also need ½-inch thick plywood to serve as the backing, so make sure to get a piece a little over 2 feet long so it wouldn't look awkward when combined with the pipes. You will also need a light like these X-PREK 2-Pack Solar Lights to illuminate your fixture. Finally, to assemble your DIY sconce, you will also need some hot glue or Gorilla Wood Glue, mounting brackets, spray paints in your preferred color, and tools like a pipe cutter, a power drill with a twist bit, and some 80-grit sandpaper for smoothing out edges.
How to DIY solar-powered sconce lamps from PVC pipes
First, make sure to wear safety equipment like gloves and a mask before cutting the 2-foot PVC pipe in half and sanding the cut edges. Then use your power drill to make small holes across the surface of each section. Don't worry if the marks aren't symmetrical; you can exercise your creative freedom here — it's your DIY, after all. If you want to give this project an artistic edge, cut abstract shapes or geometric patterns into the pipes. Once you're satisfied with your designs, spray paint the pipes and let them dry.
Next, let's move to the backing. Measure and cut the plywood into two pieces slightly longer than the size of the pipes. Saw off two 2-inch long blocks from the remaining plywood and attach these to each board, positioning them near opposite ends. These blocks will act as spacers between the backing and the PVC pipe. Afterwards, paint the boards in your hue of choice, and let that dry before attaching the mounting bracket on the back.
Before inserting the solar-powered light, glue jute rope around the inner top edge of each pipe to serve as a small cushion and help prevent the light from slipping through. Once that's done, position and glue the PVC pipe onto the wooden blocks. Make sure it is centered before leaving it to dry. Finally, mount your beautiful DIY sconce to any exterior wall that receives natural light, and insert the solar light. For the sconces to glow, avoid installing them in covered areas or places where the sun cannot reach the solar panels during daytime.