Prevent Messy Gravel Driveways When Using A Snow Plow With One Simple Change

Add House Digest on Google:

Having a gravel driveway is a solid perk for most of the year, offering great traction and zero concrete cracks to worry about. Still, while there are plenty of advantages, scattered rocks are one of the most frustrating disadvantages of gravel driveways. When the snow starts falling and you break out the snow plow, you know that the spring is going to bring you something unsightly: piles of thrown rocks in your yard. Instead of having a relaxing start to the season, you'll be spending your first warm weekends of the spring cleaning up your yard, shoveling stray gravel back into bare ruts.

You might assume that stray gravel in your yard is just the price you pay for owning a gravel driveway in a snowy climate. Or you might start thinking that it's time to start looking into expensive rubber cutting edges and aftermarket plow attachments just to save your yard. While these upgrades might be a potential remedy, the key to keeping your gravel out of your lawn comes with one simple change: adjusting your snowplow's blade height.

The steel cutting edge will dig through loose gravel in exactly the same way as packed snow. This means that the steel will dig into the gravel and push everything out of the way. By leaving only a small gap between the steel cutting edge and the surface of the driveway, you allow the plow to slide over the stones but still clear most of the snow. It can take a couple of minutes to get the adjustment right and pairing it with the lasting solution that will keep your gravel driveway fixed in place makes a massive difference to how your driveway looks in April.

How to dial in the right blade height for a gravel driveway

The height of your snow plow blade can be adjusted using the skid shoes. These little metal discs are fitted to the bottom of the blade. They help lift the cutting edge so that it doesn't dig into the loose stones but can easily glide over them. If your skid shoes are too low, your blade will be too low and simply push the gravel off the drive and onto your lawn. To adjust the skid shoes, park your snow plow on a flat surface. Lower the plow fully, then adjust the washers or pins so that the bottom of the blade is approximately a half inch to a full inch off the ground. 

When the snow does fall, you should leave a little sacrificial layer of snow, about a half an inch to one inch, and don't try to clear the driveway to absolutely clear. In fact, if the first snowfall of the season is only an inch or two deep, hold off on plowing altogether and just drive over it a few times. This will turn your gravel driveway into a smooth drive for the rest of the winter. Pairing this hack with other must-do tasks to prep your gravel driveway for winter will give you the best chance of having a clean driveway free of ruts.

Recommended